Hubbardton-forge 136555 Manuel d'utilisateur Page 3

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 2
Assembly & Installation Instructions A339
Moreau Six Light Pendant 136555 Page 3 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
24825
Install to Ceiling (Figure 5)
Component Part
E Ceiling Bracket
H Canopy
J Set Screw (2)
K Threaded Stud (2)
L #10 Wood Screws (8)
M Hex Nut
N Barrel Knobs (2)
O Cupped Washer
1. Using wood screws (L) attach ceiling bracket (E) to
a structural member in the ceiling, centering the
bracket over the outlet box. We've supplied wood
screws with your fixture; however, different
materials and/or construction methods may require
different fasteners. If in doubt, contact a qualified
electrician. Do not attach ceiling bracket directly to
outlet box.
2. Using suitable wire connectors (not provided)
connect fixture wires to supply (white to white and
black to black).
3. Using cupped washer (O) and hex nut (M) run a
pigtail lead from ceiling bracket to the junction
box. Raise canopy (H) and connect all ground
wires (bare copper or green to bare copper or
green). Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
4. Slide fixture canopy (H) over threaded studs (K)
and push firmly to ceiling, making sure that no
wires are pinched between fixture canopy and
ceiling. Fasten with barrel knobs (N). Be sure studs
(K) are fully seated in barrel knobs (N).
5. Once the fixture is fastened to the ceiling, tighten
the set screws (J) firmly with hex wrench provided.
Only after the set screws (J) are tight should you
install the glass. Be sure to tighten set screws in
both clutches.
6. Refer to instructions following to install glass.
(continued)
(Figure 5)
Vue de la page 2
1 2 3 4

Commentaires sur ces manuels

Pas de commentaire